Stripe™

For best results, use when temperature is between 40°F (5°C) and 90°F (32°C). Shake vigorously for at least one minute after rattle is heard and occasionally during use. Turn can upside down and place into can holder. Make sure that spray head fits properly into hole. Long side of spray head must be parallel to the axle. A line approximately two inches wide (5 cm) will be applied when can is in the lowest position. A line approximately four inches wide (10 cm) will be applied when can is in the highest position. Intermediate widths will result when can is positioned between highest and lowest points. Squeeze trigger to activate spray. To avoid any possible build-up of paint when starting. It is suggested that machine be in motion and trigger activated when passing over starting point. Should spray pattern become restricted after using, remove spray head briefly to clear it. One can of State Stripe will produce 360 feet (110 m) of line two inches (5 cm) wide. This will vary slightly depending on the porosity of the surface and on the speed of the applicator. Note: If greenish appearance develops on asphalt a second or third coat may be required. Allow 30minutes between coats. Does not exceed 66% VOC.