GENERAL CLEANING - Apply this product to soiled area with mop, cloth, sponge, hand pump trigger sprayer or low pressure coarse sprayer. This product can be diluted at 2 ounces per gallon of water or applied full strength. Thoroughly wet soiled surface and scrub as necessary.
DEODORIZATION - To deodorize, apply this product as indicated under the heading DISINFECTION.
MILDEWSTAT - To control mold and mildew on pre-cleaned, hard, non-porous surfaces, add 2 ounces of this product per gallon of water. Apply solution with a mop, cloth, sponge, hand pump trigger sprayer or low pressure coarse sprayer making sure to wet all surfaces completely. Let air dry. Prepare a fresh solution for each use. Repeat application at weekly intervals or when mildew growth appears.
DISINFECTION - To disinfect inanimate, hard surfaces add 2 ounces of this product per gallon of water. Apply solution with a mop, cloth, sponge, hand pump trigger sprayer or low pressure coarse sprayer so as to wet all surfaces thoroughly. Allow to remain wet for 10 minutes, then remove excess liquid. For heavily soiled areas, a pre-cleaning step is required. Prepare a fresh solution for each use.
BACTERICIDAL ACTIVITY - When diluted at the rate of 2 ounces per gallon of water, this product exhibits effective disinfectant activity against the organisms: Pseudomonas aeruginosa, Escherichia coli, Salmonella enterica, Streptococcus salivarius, Staphylococcus aureaus and meets all requirements for hospital use.
FUNGICIDAL ACTIVITY - At the 2 ounce per gallon dilution, this product is also fungicidal against the pathogenic fungi, Trichophyton mentagrophytes (Athlete’s Foot Fungus), when used as directed on hard surfaces found in bathrooms, shower stalls, locker rooms, exercise facilities or other clean, hard, non-porous surfaces commonly contacted by bare feet.
VIRUCIDAL ACTIVITY - This product, when used on environmental, inanimate, hard, nonporous surfaces at 2 ounces per gallon of water, exhibits effective virucidal activity against Herpes Simplex Type 1 (causative agent of fever blisters), Adenovirus Type 2 (causative agent of upper respiratory infections), Vaccinia virus (representative of the Pox virus group), Human Immunodeficiency Virus Type 1 (HIV-1), Human Coronavirus, Hepatitis B Virus (HBV), Hepatitis C Virus (HCV), Feline Calicivirus (FCV).
KILLS HIV-1, HBV AND HCV ON PRE-CLEANED ENVIRONMENTAL SURFACES/OBJECTS PREVIOUSLY SOILED WITH BLOOD/BODY FLUIDS in health care settings (hospitals, nursing homes) or other settings in which there is an expected likelihood of soiling of inanimate surfaces/objects with blood or body fluids, and in which the surfaces/objects likely to be soiled with blood or body fluids can be associated with the potential for transmission of Human Immunodeficiency Virus Type 1 (HIV-1) (associated with AIDS), Hepatitis B Virus (HBV) and Hepatitis C Virus (HCV).
SPECIAL INSTRUCTIONS FOR CLEANING AND DECONTAMINATION AGAINST HIV-1, HBV AND HCV ON SURFACES/OBJECTS SOILED WITH BLOOD/BODY FLUIDS:
PERSONAL PROTECTION: When handling items soiled with blood or body fluids, use disposable latex gloves, gowns, masks, or eye coverings. CLEANING PROCEDURES: Blood and other body fluids must be thoroughly cleaned from surfaces and objects before application of this product. CONTACT TIME: Allow surface to remain wet for 10 minutes. DISPOSAL OF INFECTIOUS MATERIALS: Blood and other body fluids should be autoclaved and disposed of according to local regulations for infectious waste disposal.
SANITIZATION: Recommended for use in restaurants, dairies, food processing plants and bars. When used as directed, this product is an effective sanitizer against Escherichia coli and Staphylococcus Aureus. Remove all gross food particles from soiled areas, which are to be sanitized, with a good detergent, pre-flush, pre-soak or pre-scrape treatment. Rinse with potable water rinse. To sanitize previously cleaned and rinsed, non-porous food contact surfaces, prepare a 200ppm active quaternary solution by adding 2 ounces of this product to 3.5 gallons of water. From a closed loop dilution center: Apply 200 ppm active solution to the surface to be sanitized. Surfaces should remain wet for at least 1 minute, followed by adequate draining and air drying. To sanitize immobile items such as tanks, chopping blocks and counter tops, flood area with a 200 ppm active quaternary solution or apply with a mop, cloth, sponge, hand pump trigger sprayer or low pressure coarse sprayer making sure to wet all surfaces completely for at least 60 seconds. Let air dry. Prepare a fresh solution for each use.