NOTE: DO NOT MIX THIS PRODUCT WITH OTHER BOILER/STEAM PRODUCTS. Use sufficient Superhot Boiler Treatment to achieve 30 - 60 ppm sulfite in the steam boiler. For most systems the required feed rate is 6 fluid ounces of product for every 1000 gal of fresh water make up added to the boiler. SuperHot™ Boiler Treatment is a combination of powerful scale control polymer agents and sulfite oxygen scavengers. Maintaining a sulfite level of 30 - 60 ppm will insure sufficient scale control ingredients. Add Superhot Boiler Treatment to the feedwater tank, deaerator storage tank, or condensate receiver tank. It is recommended that the product feed be automated using a State Industrial feed system and chemical metering pump for best results. If necessary Superhot Boiler Treatment may be
fed directly to the steam boiler. Use a State Industrial test kit to monitor sulfite levels daily. Feed product as needed to maintain a boiler sulfite level of 30 - 60 ppm. Also maintain the following control ranges:

Sulfite 30- 60 ppm Boiler TDS 3000 ppm max Hydrated alkalinity >200 ppm as OH P-alkalinity 300 - 500 Total alkalinity 700 ppm max Condensate pH 7.5 - 9.0

Blow Down: Blow down is a critical part of the scale control program for steam boiler systems. Perform bottom blow down as directed by your State Industrial sales professional to remove solids accumulations. Bottom blow down is required even if an automated surface blow down system is installed.

Condensate Treatment: Use State Superhot Steam Treatment to control corrosion in condensate return lines and receiver tanks. Follow label directions and maintain pH between 7.5 to 9.0.